Alientech KESS3 released a new OBD protocol for Bosch MG1CS049 “locked” ECUs on BMW M and Alpina. Work on some of the most sought-after high-performance BMW and Alpina models equipped with the 3.0 Bi-Turbo S58 engine, from 2021 onwards, directly via OBD with KESS3 and Powergate. BENCH Unlock required Read and write directly via… Read More »
A major technological breakthrough has landed on your AutoTuner Tool! AutoTuner is thrilled to announce world-first, exclusive Bench mode support for the Denso VEA Gen2 (SPC5777M) ECU family! A Look Back: In 2018, AutoTuner was the first to release support for the initial Volvo Denso ECUs (SH72546) equipping VEA engines. At that time, newer Denso ECUs powered by… Read More »
Alientech KESS3 read and write ASHOK LEYLAND 2016 bus Bosch EDC17CV54 ECU. ECU: BOSCH EDC17CV54 Mode: Boot mode, need to open ECU circuit board. Read ok. Write ok. Remove speed limit ok.
BMW MSV90 DME reading and writing with Formulaflash programmer successfully. Read ok. Write ok. Checksum correction with Formulaflash. And immo data processing. Modify VIN and ISN code.
Alientech KESS3 new user report: Toyota Kdh 201 1Kd Denso 89661-26m80 ECU ECU no communication. Recover ECU with KESS3 in boot mode.
Problem: Had a problem running CG FC200 programmer software. It recognizes the serial number but cannot run software, and I’ve changed the USB cable. Error:e126 Failed to open the device. check device connection. Solution: Restart and it will work. Restart system and connect device before you run the software.
